HSW44C 4x4 HDMI Matrix Switch with CAT5 Output Instruction Manual Made in Taiwan
9 IR Cables IR Emitter Cable IR Receiver Cable IR Sockets HSW44C IR Main: The default location for IR emit
10 Definition of IR Earphone Jack IR Emitter IR Receiver You can buy any IR extension cables in the market that ar
11 HSW44C as master 1. Connect all sources to HDMI Inputs on the HSW44C 4x4 HDMI matrix switch with CAT5 output. 2. Connect each DDC output on t
12 Source Side Method A: Push Button Push the switch button on the front panel, the source will be sequentially changed. Method B: IR Remote Con
13 Display Side Method A: Push button Push the switch buttons of respective output channels then the output channel will switch from HDMI source 1 t
14 Method C: Software Control through RS-232 Scan: Push this
15 Open: Open the COM port after scan to establish the connection between PC and the matrix. Close: Release the COM port aft
16 RSRSRSRS----232 transm232 transm232 transm232 transmission Formatission Formatission Formatission Format Baud rate: 9600 Data bit: 8 Pari
17 Warning! There could be unexpected consequences resulted from inappropriate firmware update operation. Please do it with caution. 1.
18 6. In the pop-up window, please select the [File Format] to Binary. 7. Please make sure your PC has direct connection to the RS-232 port of the
1 Safety and Notice The HSW44C 4x4 HDMI Matrix Switch with CAT5 Output has been tested for conformance to safety regulations and requ
19 1. If the DVI or HDMI device requires the EDID information, please use EDID Reader/Writer to retrieve and provide DVI/HDMI EDID information. 2
20 Cable Electronics, Inc. warrants this product to be free from defects in material and workmanship, under normal use and service, for a period o
2 The HSW44C 4x4 HDMI Matrix Switch with CAT5 Output provides the most flexible and cost effective solution in the market to route high definition
3 Features State-of-the-art Silicon Image (founder of HDMI) chipset embedded for upmost compatibility and reliability HDMI 1.2a/1.3c* compliant
4 PCB stack-up 4-layer board [impedance control — differential 100Ω; single 50Ω] Input 4x HDMI 1x RS-232 1x RJ-45 TMDS 1x RJ-45 DDC 1x IR socket for
5 HSW44C 1. Power: Power indicator LED 2. IR: IR receiver 3. Input: Input source indicator LED 4. HP1–HP4: Connection status indicator LED
6 HSMR 1. Source LED: Indicate input source 2. IN: Push button for switching input source channel in sequential order 3. EQ: Adjust the 8-
7 SW1-SW4 for EDID/Audio Note 1 If the HDTV shows video but without audio, please try to set audio mode to stereo. 2Factory default of SW
8 SW Main for firmware update (for technical support only) DIP Switch Position Pin#1 Pin#2 Pin#3 Pin#4 Normal Operation Mode6 OFF [] OFF [] ON
Kommentare zu diesen Handbüchern